Difference between revisions of "TrigBoardLightDetec"

From Kevin Darrah Wiki
Jump to: navigation, search
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
 
...Back to [[Projects:]]
 
...Back to [[Projects:]]
  
[[File:trigwaterLevel.png|800px]]
+
[[File:lightDetectPic.JPG|800px]]
  
 
Very useful if you want to wake the trigBoard up when a light switch is flipped in a room!  Note that if you want to also check if the light is still on, check [[TrigBoardStillOn | this out]]
 
Very useful if you want to wake the trigBoard up when a light switch is flipped in a room!  Note that if you want to also check if the light is still on, check [[TrigBoardStillOn | this out]]
 +
 +
I actually found that LED I used, bought from Sparkfun back in 2010.... was [https://www.sparkfun.com/products/10023 COM-10023] and still seems to be available. 
 +
 +
[[File:trigBoardLightDEtectDiag.png|800px]]
 +
 
{{#evt:
 
{{#evt:
 
service=youtube
 
service=youtube
|id=https://youtu.be/nlwGhRXQSZc
+
|id=https://youtu.be/IZu17RKsjxQ
 
|dimensions=560x315
 
|dimensions=560x315
 
}}
 
}}
 
Here's the diagram for hooking up the probe:
 
NOTE!  I noticed when hooking up the wire to ground as shown in the video that the range was severely reduced.  I tried connecting it like it is here in the diagram and get much better performance
 
 
[[File:trigWaterDiagv2.png|600px]]
 
 
Make sure to set the jumpers properly, so you wake the board up when water is detected:
 
 
[[File:trigWaterJumpers.png|400px]]
 

Latest revision as of 14:58, 4 November 2019

...Back to Projects:

LightDetectPic.JPG

Very useful if you want to wake the trigBoard up when a light switch is flipped in a room! Note that if you want to also check if the light is still on, check this out

I actually found that LED I used, bought from Sparkfun back in 2010.... was COM-10023 and still seems to be available.

TrigBoardLightDEtectDiag.png