Difference between revisions of "Stepper Board"
From Kevin Darrah Wiki
| Line 19: | Line 19: | ||
== Parts == | == Parts == | ||
| − | + | Parts can be downloaded [[:File:StepBoardV1.xlsx]HERE] | |
== Assembly == | == Assembly == | ||
Revision as of 06:38, 31 May 2017
...Back to Projects:
Contents
The Stepper Board
Introduction
This board is based on the DRV8825 Stepper Motor Driver. It works with standard x4 wire bipolar stepper motors.
- Motor Voltage Supply from 8.2V to 45V
- Phase Current up to 2.5A, but ~1A is more realistic without a heatsink and fan
- Built in Step Controller, so strap the mode pins for the step mode: Full, Half, and Micro stepping.
- Easy control from a Microcontroller, digital pins to set the direction, enable the part, and step the motor.
- Fault Output Pin broken out and max current setting with a trim pot
Schematic
Purchase
given to Patrons ...
Parts
Parts can be downloaded [[:File:StepBoardV1.xlsx]HERE]
Assembly
Coming Soon...
Tutorials
Little refresher on how stepper motors work:
