Difference between revisions of "Stepper Board"
From Kevin Darrah Wiki
| Line 25: | Line 25: | ||
== Tutorials == | == Tutorials == | ||
| + | |||
| + | Little refresher on how stepper motors work: | ||
{{#evt: | {{#evt: | ||
service=youtube | service=youtube | ||
Revision as of 21:35, 17 May 2017
...Back to Projects:
Contents
The Stepper Board
Introduction
This board is based on the DRV8825 Stepper Motor Driver. It works with standard x4 wire bipolar stepper motors.
- Motor Voltage Supply from 8.2V to 45V
- Phase Current up to 2.5A, but ~1A is more realistic without a heatsink and fan
- Built in Step Controller, so strap the mode pins for the step mode: Full, Half, and Micro stepping.
- Easy control from a Microcontroller, digital pins to set the direction, enable the part, and step the motor.
- Fault Output Pin broken out and max current setting with a trim pot
Schematic
Purchase
given to Patrons ...
Parts
Coming Soon...
Assembly
Coming Soon...
Tutorials
Little refresher on how stepper motors work:
